TIRE AND WHEEL SYSTEM INSPECTION

PROCEDURE


  1. INSPECT TIRES


    1. Inspect the tires for wear and proper inflation pressure.

      Cold Tire Inflation Pressure
      Tire Size Cold Tire Inflation Pressure
      Front Rear
      215/55R17 94W

      230 kPa (2.3 kgf/cm2, 33 psi)

      230 kPa (2.3 kgf/cm2, 33 psi)
    2. A01MIXA

      Using a dial indicator, check the runout of the tires.

      Maximum Tire Runout
      1.4 mm (0.0551 in.)

      Tech Tips

      Measure the runout with the wheel assembly removed from the vehicle.

  2. ROTATE TIRES


    1. Remove the wheel assembly.

      Click here

    2. A01MIIEC13
      B006JEG Front of the Vehicle

      Rotate the tires as shown in the illustration.

    3. Install the wheel assembly.

      Click here

  3. INSPECT AND ADJUST WHEEL BALANCE


    1. A01MGOLC01
      *a 25 mm (0.984 in.)

      Inspect and adjust the off-the-car balance.

      Maximum Wheel Imbalance
      8.0 g (0.0176 lb)

      Note


      • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

      • Do not touch the adhesive surface of the balance weight.

      • Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.

      • Push the balance weight with your finger to securely adhere it to the desired position.

      • Do not reuse balance weights.

      • Use only TOYOTA genuine stick-on type balance weights or equivalent.

      Tech Tips


      • Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.

      • If the tires vibrate even after off-the-car balance adjustment, adjust the wheel balance with on-the-car balancing as necessary.

  4. INSPECT FRONT AXLE HUB BEARING

    Click here

  5. INSPECT REAR AXLE HUB BEARING

    Click here