FRONT DRIVE SHAFT ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | NO. 1 MOTOR UNDER COVER | *2 | FILLER PLUG |
| *3 | DRAIN PLUG | *4 | GASKET |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | FRONT AXLE SHAFT NUT | *2 | FRONT DRIVE SHAFT ASSEMBLY |
| *3 | FRONT FLEXIBLE HOSE | *4 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY |
| *5 | FRONT SPEED SENSOR | *6 | FRONT STABILIZER LINK ASSEMBLY |
| *7 | TIE ROD END SUB-ASSEMBLY | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
 |
Do not apply lubricants to the threaded parts | - | - |
ILLUSTRATION
| *1 | FRONT DRIVE INBOARD JOINT LH HOLE SNAP RING | *2 | FRONT DRIVE SHAFT ASSEMBLY LH |
| *3 | FRONT DRIVE INBOARD JOINT RH HOLE SNAP RING | *4 | FRONT DRIVE SHAFT ASSEMBLY RH |
| ● | Non-reusable part |  |
Toyota Genuine ATF WS |
 |
MP grease | - | - |
ILLUSTRATION
| *A | for LH Side | - | - |
| *1 | FRONT AXLE INBOARD JOINT BOOT LH CLAMP | *2 | FRONT AXLE OUTBOARD JOINT BOOT |
| *3 | FRONT AXLE OUTBOARD JOINT BOOT LH CLAMP | *4 | FRONT DRIVE INBOARD JOINT ASSEMBLY LH |
| *5 | FRONT AXLE INBOARD JOINT BOOT | *6 | FRONT DRIVE SHAFT DUST COVER LH |
| *7 | FRONT NO. 2 AXLE INBOARD JOINT BOOT LH CLAMP | *8 | FRONT NO. 2 AXLE OUTBOARD JOINT BOOT LH CLAMP |
| *9 | FRONT DRIVE INNER SHAFT INNER LH SHAFT SNAP RING | *10 | TRIPOD JOINT |
| *11 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY LH | - | - |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *A | for RH Side | - | - |
| *1 | FRONT AXLE INBOARD JOINT BOOT RH CLAMP | *2 | FRONT DRIVE INBOARD JOINT ASSEMBLY RH |
| *3 | FRONT AXLE INBOARD JOINT BOOT | *4 | FRONT DRIVE SHAFT DUST COVER RH |
| *5 | FRONT NO. 2 AXLE INBOARD JOINT BOOT RH CLAMP | *6 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY RH |
| *7 | TRIPOD JOINT | *8 | FRONT DRIVE INNER SHAFT INNER RH SHAFT SNAP RING |
| ● | Non-reusable part | - | - |