LANE RECOGNITION CAMERA SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lane departure warning camera removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effects/Inoperative when not Performed Link
Removal/installation of lane departure warning camera Adjust lane departure warning camera Lane departure alert system

Click here

Note


  • When replacing the lane departure warning camera, make sure to replace it with a new one.

  • Do not touch the lens surface of the lane departure warning camera and the windshield in front of the lane departure warning camera.

  • If the lane departure warning camera is dropped, replace it with a new one

  • If the windshield glass is replaced on a vehicle equipped with a lane departure warning camera, make sure to use a Toyota genuine part, as the lane departure warning camera may not be able to be installed due to a missing bracket or the lane departure alert system may not operate properly due to a difference in the transmissivity or ceramic line shape.

PROCEDURE


  1. REMOVE NO. 1 LANE RECOGNITION COVER


    1. A01MGVMC01
      B006JFV Remove in this Direction

      Pull in the direction indicated by the arrow shown in the illustration to disengage the 4 guides to remove the No. 1 lane recognition cover.

  2. REMOVE LANE DEPARTURE WARNING CAMERA


    1. Disconnect the connector.

      A01MHBYC01
      *a Pin on the front side of the lane departure warning camera *b Pin on the rear side of the lane departure warning camera
      *c Guide - -
      B006JFV Remove in this Direction (1) B006JHL Remove in this Direction (2)

      Note

      Do not pull the harness forcibly when disconnecting the connector.

    2. As shown in the illustration, push the bracket towards the rear, and disengage the pin on the front side of the lane departure warning camera from the hole on the front side of the bracket.

    3. While pulling the lane departure warning camera down, remove the 2 rear lane departure warning camera pins from the guides.

      Note

      Do not touch the lens surface of the lane departure warning camera.