DYNAMIC RADAR CRUISE CONTROL SYSTEM OPERATION CHECK


  1. INPUT SIGNAL CHECK

    A01MJV6C01
    *a ON/OFF
    *b -SET
    *c +RES
    *d CANCEL
    *e MODE

    1. Connect the GTS to the DLC3.

    2. Check the cruise control main switch using the Data List function of the GTS (ON/OFF, -SET, +RES, CANCEL and MODE).

  2. INSPECT MODE SWITCH

    A01MG18C02
    *a ON/OFF
    *b MODE

    1. Turn the power switch on (IG).

    2. Turn the cruise control system on using the cruise control main switch (ON/OFF). Then push the cruise control main switch to MODE for 1 second or more to switch to the constant speed control mode.

    3. A01MHVQC01
      *a

      Cruise Control Indicator Light

      (Vehicle-to-vehicle distance control mode)
      *b

      Cruise Control Indicator Light

      (Constant speed control mode)

      Check that the cruise control indicator light (vehicle-to-vehicle distance control mode) goes off and the cruise control indicator light (constant speed control mode) illuminates.

      Note

      Do not push any other switches before pushing the cruise control main switch to MODE. If another switch is pushed, turn the cruise control system off and repeat the procedure above.

      Tech Tips

      If a malfunction is detected, turn the power switch off and repeat the procedure above.

  3. INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Turn the power switch on (IG).

    2. Turn the cruise control system on using the cruise control main switch (ON/OFF).

    3. A01MJVKC02
      *1 Distance Control Switch

      Press the steering pad switch assembly (distance control switch).

    4. Check that the indication of the vehicle-to-vehicle distance, which is shown on the multi-information display in the combination meter assembly changes from long to middle to short in that order.

      A01MHWAC02
      *1 Long *2 Middle
      *3 Short - -

      Tech Tips

      Long is automatically selected each time the power switch is on (READY).