REGULATOR ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | NO. 1 FLOOR UNDER COVER | *2 | NO. 2 FLOOR UNDER COVER |
| *3 | FRONT FLOOR CENTER COVER LH | *4 | FRONT FLOOR CENTER COVER RH |
| *5 | FRONT FLOOR COVER LH | *6 | FRONT FLOOR COVER RH |
| *7 | NO. 2 MOTOR UNDER COVER | - | - |
ILLUSTRATION
| *1 | FC EXHAUST TAIL PIPE ASSEMBLY | *2 | NO. 2 FC EXHAUST PIPE |
| *3 | NO. 3 FC EXHAUST PIPE | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | LUGGAGE TRIM SERVICE HOLE COVER | *2 | NEGATIVE AUXILIARY BATTERY TERMINAL |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | REAR BUMPER SIDE SEAL LH | *2 | REAR WHEEL HOUSE FRONT PLATE LH |
| *3 | REAR WHEEL HOUSE LINER LH | - | - |
ILLUSTRATION
| *1 | FUEL LID WITH MOTOR LOCK ASSEMBLY | *2 | NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY |
| *3 | FRONT LUGGAGE COMPARTMENT TRIM COVER | *4 | LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH |
| *5 | NO. 2 LUGGAGE COMPARTMENT TRIM HOOK | *6 | LUGGAGE COMPARTMENT FLOOR MAT |
| *7 | REAR FLOOR FINISH PLATE | *8 | ROPE HOOK |
ILLUSTRATION
| *1 | HYDROGEN INLET RECEPTACLE CAP | *2 | FUEL TANK CAP COVER |
| *3 | FUEL TANK FILLER PIPE SHIELD | *4 | FUEL FILLER OPENING LID SUB-ASSEMBLY |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *1 | NO. 2 PARKING BRAKE CABLE ASSEMBLY | *2 | NO. 3 PARKING BRAKE CABLE ASSEMBLY |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | HYDROGEN INLET RECEPTACLE BRACKET SUB-ASSEMBLY | *2 | NO. 1 HYDROGEN SUPPLY TUBE SUB-ASSEMBLY |
| *3 | NO. 2 HYDROGEN SUPPLY TUBE SUB-ASSEMBLY | *4 | WIRE HARNESS CLAMP BRACKET |
| *5 | O-RING | *6 | HYDROGEN TANK TUBE CLAMP BRACKET |
| *7 | HYDROGEN TANK UNIT | *8 | NO. 1 HYDROGEN SUPPLY REGULATOR PLUG |
| *9 | HYDROGEN SUPPLY REGULATOR UNION | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with 17 mm union nut wrench | ● | Non-reusable part |
 |
TOYOTA Genuine FC Grease | - | - |
ILLUSTRATION
| *1 | HYDROGEN SUPPLY REGULATOR ASSEMBLY | *2 | NO. 6 HYDROGEN TANK TUBE |
| *3 | HYDROGEN TANK TUBE JOINT SUPPLY BRACKET | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with 17 mm union nut wrench | ● | Non-reusable part |