HYDROGEN DETECTOR(for Motor Room Side) ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT HYDROGEN DETECTOR


    1. Remove the inverter cover.

      Click here

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Enter the following menus: Powertrain / FC / Data List / Motor Room Side Hydrogen Detector Density.


      Powertrain > FC > Data List
      Tester Display
      Motor Room Side Hydrogen Detector Density
    5. A01MFHFC04
      *a Hydrogen Gas for Inspection
      *b Hydrogen Detecting Portion

      Cover the hydrogen detecting portion of the hydrogen detector with SST.

      SST
      09405-62010   ( 09405-06010 )

    6. While injecting hydrogen gas, check the hydrogen concentration displayed on the GTS.

      OK
      0.9 to 1.6 %

      Note

      Use hydrogen gas at 1.3% concentration.

      Tech Tips

      The value stabilizes approximately 5 seconds after hydrogen gas injection.

      If the result is not as specified, replace the hydrogen detector.

    7. Install the inverter cover.

      Click here