INTAKE AIR TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

When the vehicle is parked with the power switch off, if the FC control ECU judges that the FC stack temperature will go below 0°C (32°F), it activates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds and drains water from the FC stack assembly. When performing inspection or repairs with the power switch off (not on (IG) or on (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work.

PROCEDURE


  1. REMOVE FRONT WHEEL RH

    Click here

  2. REMOVE REAR MOTOR UNDER COVER RH

    Click here

  3. REMOVE FC GAS TEMPERATURE SENSOR


    1. A01MG8G

      Disconnect the FC gas temperature sensor connector.

      Note

      Do not allow foreign matter or water droplets to enter the connector.

    2. A01MGI0E02

      Using SST, remove the FC gas temperature sensor from the FC air compressor with motor assembly.

      SST
      09817-33191

      Note


      • Do not use an impact wrench or other tools which subject parts to an impact.

      • If the FC gas temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

      • If the gasket has any damage, deformation, or fatigue, replace the FC gas temperature sensor with a new one.

    3. A01MIY5C03
      *a Protective Tape

      To prevent contamination by foreign matter, cover the openings of the FC air compressor with motor assembly with protective tape.