SERVICE PLUG GRIP INSPECTION

PROCEDURE


  1. INSPECT FC STACK SERVICE PLUG GRIP


    1. A01MHO3C02
      *a

      Component without harness connected

      (FC Stack Service Plug Grip)

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 4 Always Below 1 Ω
        3 - 5 Always 10 kΩ or higher
        3 - 6 Always 10 kΩ or higher
        4 - 5 Always 10 kΩ or higher
        4 - 6 Always 10 kΩ or higher
        5 - 6 Always Below 1 Ω

        Note

        Inspect the FC stack service plug grip terminal while making sure not to scratch or damage it.

        If the result is not as specified, replace the FC stack service plug grip.