SERVICE PLUG GRIP INSTALLATION

PROCEDURE


  1. INSTALL SERVICE PLUG GRIP (for EV)

    CAUTION:

    Wear insulated gloves.

    Note

    Before connecting the removed service plug grip (for EV), check that no components or tools have been left behind, and check that high voltage terminals are tightened and connectors are connected


    1. To prevent contamination by foreign matter or water droplets, remove the protective tapes from the openings of the service plug grip (for EV) and EV battery immediately before performing the procedure.

    2. A01MHA9C02
      B006JEG Push In

      Slowly push in the service plug grip (for EV) until its lever contacts the stopper to install the service plug grip (for EV) to the EV battery.

    3. A01MFSGC03
      B006JEG Rotating Direction

      Slowly rotate the lever of the service plug grip (for EV) in the direction shown in the illustration until it contacts the stopper.

      Note

      Do not excessively twist the lever of the removed service plug grip (for EV).

    4. A01MJDOC02
      B006JEG Sliding Direction

      Slide the lever of the service plug grip (for EV) in the direction shown in the illustration until it contacts the stopper.

      Note


      • Slowly slide the lever of the removed service plug grip (for EV) in the until the word "UNLOCK" disappears completely.

      • The removed service plug grip (for EV) has an interlock connector, so slide it horizontally.

      • After lowering the removed service plug grip (for EV) 90°, securely slide it until a "click" sound is heard.

      A01MGNTC07
      *a Correct
      *b Incorrect

  2. INSTALL NO. 8 EV BATTERY SHIELD PANEL


    1. Install the No. 8 EV battery shield panel to the EV battery with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  3. INSTALL LUGGAGE COMPARTMENT TRIM FRONT COVER

    Click here

  4. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

  5. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  6. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here