BLACK OUT TAPE(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REPAIR INSTRUCTION

    Click here

  2. INSTALL NO. 2 BLACK OUT TAPE LH

    Tech Tips

    When installing the No. 2 black out tape LH, heat the rear door panel and No. 2 black out tape LH using a heat light.

    Standard
    Item Temperature
    Rear Door Panel 40 to 60°C (104 to 140°F)
    No. 2 Black Out Tape LH 20 to 30°C (68 to 86°F)

    CAUTION:


    • Do not touch the heat light and heated parts.

    • Touching the heat light may result in burns.

    • Touching heated parts for a long time may result in burns.

    B0068O1C23
    *a Heated Part
    *b Heat Light

    1. Refer to the illustration to position a new No. 2 black out tape LH.

      B0068BJC01
      *a Edge of Curved Surface - -
      Standard
      Area Specified Condition Area Specified Condition
      A -1.0 to 1.0 mm (-0.0394 to 0.0394 in.) B 3.0 to 5.0 mm (0.118 to 0.197 in.)
      C 3.0 mm (0.118 in.) D 0 to 2.0 mm (0 to 0.0787 in.)

    2. Remove the release paper from the No. 2 black out tape LH.

    3. After installing the No. 2 black out tape LH, remove the unnecessary part above the perforation.

  3. INSTALL REAR DOOR WEATHERSTRIP LH


    1. B0028WI

      Attach the clip to install the rear door weatherstrip LH.

  4. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

    Click here

  5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  7. INSTALL REAR DOOR GLASS RUN LH

    Click here

  8. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  11. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  12. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  13. INSTALL REAR ARMREST ASSEMBLY LH

    Click here

  14. INSTALL REAR DOOR FRAME GARNISH LH

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here