FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Fully open the front door glass sub-assembly LH before proceeding with work.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    w/ Curtain Shield Airbag:

    Be sure to read Precaution thoroughly before servicing.

    B0069A2

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    w/ Curtain Shield Airbag:

    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B00693Q

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. REMOVE FRONT ARMREST ASSEMBLY LH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side, w/ Power Window)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side, w/ Power Window)

    Click here

  7. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  8. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  12. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  13. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  14. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH


    1. A01SJKAC01
      *A except Double Cab
      *B for Double Cab
      B00692L Protective Tape

      Put protective tape around the front door belt moulding assembly LH.

    2. A01SIYKC01
      *A except Double Cab
      *B for Double Cab
      B0069FO Remove in this Direction

      Using moulding remover D, detach the claw and remove the front door belt moulding assembly LH as shown in the illustration.