Click here

HEIGHT CONTROL SENSOR REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear height control sensor sub-assembly installation/removal are shown below.

Table 1. Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components Headlight leveling ECU assembly initialization Automatic headlight beam level control system

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE HEIGHT CONTROL LINK COVER


    1. A01LETK

      Remove the 2 bolts and height control link cover.

  2. Click here

    REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A01LE9X

      Disconnect the connector.

    2. A01L9KJ

      Remove the 3 bolts and rear height control sensor sub-assembly LH.

    3. A01L9QO

      Detach the wire harness clamp.

      Note:

      If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.