HAZARD WARNING SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL CLOCK ASSEMBLY (Hazard Warning Switch)


    1. Install the clock assembly with the screw.

    2. Connect the connector.

  2. INSTALL NO. 2 HEATER TO REGISTER DUCT (w/ Navigation System)

    Click here

  3. INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)

    Click here

  4. INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)

    Click here

  5. INSTALL DEFROSTER NOZZLE ASSEMBLY (w/ Navigation System)

    Click here

  6. INSTALL UPPER INSTRUMENT PANEL

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  8. PERFORM DIAGNOSTIC SYSTEM CHECK

    for Type A:

    Click here

    for Type B:

    Click here

  9. CHECK SRS WARNING LIGHT

    for Type A:

    Click here

    for Type B:

    Click here