AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK


  1. AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK


    1. Check that the initialization (determination of the initial position) of the headlight leveling motor (headlight assembly) is performed when the engine switch is turned on (IG).

    2. Check that the headlight beam level control system warning light in the combination meter comes on for approximately 3 seconds when the engine switch is turned on (IG), and then turns off.

    3. Check that the headlight moves when all of the following conditions are met: 1) the rear of the vehicle is moved up or down, 2) the engine is running, 3) the vehicle is stopped, and 4) the light control switch is in the head position.

      Note

      Make sure to change the vehicle height slowly.