WASHER MOTOR(for Steel Type Bumper) REMOVAL

PROCEDURE

1. Click here

   REMOVE FRONT FENDER SPLASH SHIELD FRONT SEAL LH

   
   
   1. 

      Remove the 5 screws and front fender splash shield front seal LH.

2. Click here

   DRAIN WASHER FLUID

   
   
   1. 

      Slide in this Direction

      Remove the 10 clips.

   2. Slide the front fender liner LH toward the rear of the vehicle and down to create a clearance as shown in the illustration.

   3. 

      Disconnect the washer hose and drain the washer fluid.

      Note:

      Prepare a container before performing the procedure.

3. Click here

   REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

   
   
   1. 

      Remove in this Direction

      Disconnect the connector.

   2. Pull as shown in the illustration to remove the windshield washer motor and pump assembly.

4. Click here

   REMOVE WASHER INLET SUB-ASSEMBLY

   
   
   1. 

      Remove in this Direction

      Detach the claw and guide and remove the washer inlet sub-assembly.

5. Click here

   REMOVE WINDSHIELD WASHER JAR ASSEMBLY

   
   
   1. 

      Detach the clamp.

   2. Remove the 3 bolts and windshield washer jar assembly.