POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

   
   

   1. Apply MP grease to the sliding and rotating areas of the regulator motor.

   2. 

      w/ Jam Protection Function:

      Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

   3. 

      w/o Jam Protection Function:

      Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

   Click here

3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

   Click here

4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

   Click here

5. INSTALL REAR DOOR GLASS RUN LH

   Click here

6. INSTALL REAR DOOR SERVICE HOLE COVER LH

   Click here

7. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

8. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

9. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

10. INSTALL REAR LH ARMREST ASSEMBLY

    Click here

11. INSTALL REAR DOOR FRAME GARNISH LH

    Click here

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here