POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   CAUTION:
   

   Be sure to read Precaution thoroughly before servicing.

   for Type A:

   Click here

   for Type B:

   Click here

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

   Click here

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:
   

   
   

   • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   • If the airbag deploys for any reason, it may cause a serious accident.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. Click here

   REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

   Click here

4. Click here

   REMOVE FRONT ARMREST ASSEMBLY LH

   Click here

5. Click here

   REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click here

6. Click here

   REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

   Click here

7. Click here

   REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

8. Click here

   REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

9. Click here

   REMOVE FRONT DOOR SERVICE HOLE COVER LH

   Click here

10. Click here

    REMOVE FRONT DOOR GLASS RUN LH

    Click here

11. Click here

    REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

12. Click here

    REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

13. Click here

    REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    
    
    1. 

       Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.

    2. 

       for Front Passenger Side, w/o Jam Protection Function:

       Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly RH.