Click here

COMPRESSOR(for 1GR-FE) DISASSEMBLY

Click here
Click here Click here

PROCEDURE


  1. Click here

    REMOVE COOLER BRACKET


    1. B00283AC01
      *A w/o Thermostat
      *B w/ Thermostat

      w/ Thermostat:


      1. Disconnect the connector.

    2. Detach the clamp.

    3. Remove the screw and cooler bracket.

  2. Click here

    REMOVE MAGNET CLUTCH ASSEMBLY


    1. B0024USC01
      *A w/o Thermostat *B w/ Thermostat
      *a SST - -

      Clamp the compressor assembly with magnet clutch in a vise between aluminum plates.

    2. Using SST, hold the magnet clutch hub.

      09985-00270

    3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      Tip:

      There is no set number of magnet clutch washers that are used for adjusting clutch clearance.

    4. B0027DRC01
      *A w/o Thermostat *B w/ Thermostat

      Using a snap ring expander, remove the snap ring and magnet clutch rotor.

      Note:

      Do not damage the seal cover of the bearing when removing the snap ring.

    5. B0026ULC01
      *A w/o Thermostat *B w/ Thermostat

      Using a snap ring expander, remove the snap ring and magnet clutch stator.