COMPRESSOR(for 2KD-FTV) DISASSEMBLY

PROCEDURE


  1. REMOVE COOLER BRACKET


    1. B00290JC03
      *A w/o Thermostat, for Type A
      *B w/ Thermostat

      w/ Thermostat:

      Disconnect the connector.

    2. w/ Thermostat:

      Detach the clamp.

    3. Remove the screw and cooler bracket.

  2. REMOVE MAGNET CLUTCH ASSEMBLY


    1. B0024U0C02
      *A w/o Thermostat, for Type A
      *B w/ Thermostat
      *a SST

      Clamp the compressor assembly with magnet clutch in a vise between aluminum plates.

    2. Using SST, hold the magnet clutch hub.

      SST
      09985-00040

    3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

      Tech Tips

      There is no set number of magnet clutch washers that are used for adjusting clutch clearance.

    4. B00291LC02
      *A w/o Thermostat, for Type A
      *B w/ Thermostat

      Using a snap ring expander, remove the snap ring and magnet clutch rotor.

      Note

      Do not damage the seal cover of the bearing when removing the snap ring.

    5. B0026YKC02
      *A w/o Thermostat, for Type A
      *B w/ Thermostat

      Using a snap ring expander, remove the snap ring and magnet clutch stator.