REAR SEAT OUTER BELT ASSEMBLY(for Double Cab) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

    B00286QC01
    *a Bolt A
    *b Bolt B

    1. Attach the 2 guides and temporarily install the rear No. 1 seat outer belt assembly LH with the 2 bolts.

    2. Tighten the 2 bolts in the order shown in the illustration.

      Torque:
      for Bolt A
      12.5 N*m  { 127 kgf*cm, 9 ft.*lbf }
      for Bolt B
      42.0 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. B0027LN

      Connect the shoulder anchor of the rear No. 1 seat outer belt assembly LH with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    4. B0024DXC01
      *a Mark
      B006964 Front

      Install the bolt and connect the floor anchor of the rear No. 1 seat outer belt assembly LH as shown in the illustration.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    5. Check that the ELR locks.

      Note

      The check should be performed with the rear No. 1 seat outer belt assembly LH installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  2. INSTALL LOWER QUARTER TRIM PANEL LH

    Click here

  3. INSTALL SEAT BELT ANCHOR COVER CAP

    Click here

  4. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  5. INSTALL REAR SEAT ASSEMBLY


    1. for Seat Cushion 60/40 Split Type:

      Click here

    2. for Seat Cushion Bench Type:

      Click here