Click here

FRONT SEAT OUTER BELT ASSEMBLY(for Single Cab) REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    CAUTION:
    B0069A2

    Be sure to read Precaution thoroughly before servicing.

    for Type A:

    Click here

    for Type B:

    Click here

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:
    B00693Q

    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. Click here

    REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  4. Click here

    REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)


    1. B0027NB

      Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly LH.

  5. Click here

    REMOVE SEAT BELT ANCHOR COVER CAP

    Click here

  6. Click here

    REMOVE LOWER QUARTER TRIM PANEL LH

    Click here

  7. Click here

    REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    1. B0024ZU

      Remove the bolt and disconnect the shoulder anchor of the front seat outer belt assembly LH.

    2. B0027I5C01
      *1 Locking Button
      B00692L Protective Tape

      w/ Pretensioner:


      1. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.

        Tip:

        Tape the screwdriver tip before use.

      2. B0027AS

        Remove the 2 bolts.

      3. Detach the 2 guides and remove the front seat outer belt assembly LH.

    3. B0025VV

      w/o Pretensioner:


      1. Remove the 2 bolts.

      2. Detach the 2 guides and remove the front seat outer belt assembly LH.