OCCUPANT DETECTION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed or replaced during the occupant detection sensor removal / installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-collision system

Click here

CAUTION:


  • B0025TC

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY RH (for Separate Seat Type)

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY RH (for Bench Seat Type)

    Click here

  3. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Separate Seat Type)

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD RH (for Separate Seat Type)

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  5. REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Separate Seat Type)

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  6. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Separate Seat Type)

    Click here

  7. REMOVE FRONT SEAT BACK FRAME SUB-ASSEMBLY RH (for Separate Seat Type)

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  8. REMOVE SEAT CUSHION COVER WITH PAD (for Separate Seat Type)

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR) (for Separate Seat Type)


    1. B0026SU

      Remove the 2 hog rings and disconnect the 2 straps of the separate type front seat cushion cover from the separate type front seat cushion pad.

    2. B0025V0

      Remove the 18 hog rings and separate type front seat cushion cover.

  10. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Bench Seat Type)

    Click here

  11. REMOVE FRONT SEAT CUSHION SHIELD RH (for Bench Seat Type)

    Click here

  12. REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Bench Seat Type)

    Click here

  13. REMOVE SEATBACK COVER WITH PAD (for Bench Seat Type)

    Click here

  14. REMOVE SEAT CUSHION COVER WITH PAD (for Bench Seat Type)

    Click here

  15. REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR) (for Bench Seat Type)


    1. B0027ZB

      Remove the 7 hog rings and separate type front seat cushion pad.