FRONT SEATBACK HEATER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be per formed after parts are removed, installed, or replaced during the front seatback heater removal / installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-crash safety system

Click here

CAUTION:


  • B0025TC

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  2. REMOVE FRONT SEAT HEADREST ASSEMBLY

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  3. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)


    1. B0027BUC01
      B0069FO Removal in this Direction
      B00692L Protective Tape

      With the reclining adjuster release handle LH pulled up.

    2. Using a thin-bladed screwdriver with its tip wrapped in protective tape, detach the claw and remove the reclining adjuster release handle LH while moving it in the removal direction shown in the illustration.

      Tech Tips

      Tape the thin-bladed screwdriver tip before use.

  4. REMOVE VERTICAL ADJUSTING HANDLE LH (for Manual Seat)

    Click here

  5. REMOVE POWER SEAT SWITCH KNOB LH (for Slide and Vertical, Lifter, for Power Seat)

    Click here

  6. REMOVE POWER SEAT SWITCH KNOB LH (for Reclining, for Power Seat)

    Click here

  7. REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH (for Power Seat)

    Click here

  8. REMOVE FRONT SEAT CUSHION SHIELD LH

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  9. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  10. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  11. REMOVE FRONT SEATBACK FRAME SUB-ASSEMBLY LH

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  12. REMOVE FRONT NO. 1 SEATBACK HOOK (w/ Front No. 1 Seatback Hook)

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  13. REMOVE FRONT SEAT HEADREST SUPPORT

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  14. REMOVE SEATBACK COVER WITH PAD

    for Manual Seat:

    Click here

    for Power Seat:

    Click here

  15. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    1. B0028RU

      for Basic Style:


      1. Remove the 6 hog rings.

      2. B0026FK

        Remove the seat cover wire.

    2. B002855

      for High Style:


      1. Remove the 12 hog rings.

      2. B0027J8

        Remove the seat cover wire.