Click here

PRE-CRASH SAFETY SYSTEM ECU Power Source Circuit

Click here
Click here
DTC Code DTC Name
  ECU Power Source Circuit
Click here

DESCRIPTION

This circuit supplies power to the millimeter wave radar sensor assembly when the ignition switch to ON.

Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • w/ Stop and Start System:

    As the millimeter wave radar sensor assembly is supplied power from the engine stop and start ECU, make sure that the stop and start system is not malfunctioning before performing the following inspection procedure.

  • w/o Stop and Start System:

    Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY (IGB VOLTAGE)


    1. B0024I2C66
      *a

      Front view of wire harness connector

      (to Millimeter Wave Radar Sensor Assembly)

      Disconnect the A64 millimeter wave radar sensor assembly connector.

    2. Turn the ignition switch to ON.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A64-8 (IGB) - Body ground Ignition switch ON

      11 to 14 V*1

      10.5 to 16 V*2
      *1: w/o Stop and Start System *2: w/ Stop and Start System

    4. Turn the ignition switch off.

    5. Reconnect the A64 millimeter wave radar sensor assembly connector.

      Result
      Proceed to
      OK
      NG (w/o Stop and Start System)
      NG (w/ Stop and Start System)

    • OKClick here
    • NG (w/o Stop and Start System)

      REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

    • NG (w/ Stop and Start System)

      INSPECT STOP AND START SYSTEM (BACKUP BOOST CONVERTER CIRCUIT)Click here

  2. Click here

    CHECK HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)


    1. B0024I2C67
      *a

      Front view of wire harness connector

      (to Millimeter Wave Radar Sensor Assembly)

      Disconnect the A64 millimeter wave radar sensor assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A64-1 (SGND) - Body ground Always Below 1 Ω

    3. Connect the A64 millimeter wave radar sensor assembly connector.

      Result
      Proceed to
      OK
      NG

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR