FRONT FLOOR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT FLOOR SIDE AIRBAG SENSOR


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • B00693Q

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • B0068ME

        If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the front floor side airbag sensor. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.

    3. B006968C01
      *A for Single Cab, Smart Cab
      *B for Double Cab

      Attach the guide and hold the front floor side airbag sensor in place.

    4. Install the nut.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the front floor side airbag sensor has been dropped, replace it with a new one.

      • When installing the front floor side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Tighten the bolt while holding the front floor side airbag sensor because the front floor side airbag sensor guide is easily damaged.

    5. Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

      B0068EHC02
      *a Correct *b Incorrect

    6. Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. While holding the CPA be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

        Note

        Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

        B0069CNC02
        *a Housing Lock *b CPA
        *c CPA Upper Part *d Connection is Completed
        B0069FO Connect Direction - -

    7. Check that there is no looseness in the installation parts of the front floor side airbag sensor.

  2. INSTALL LOWER CENTER PILLAR GARNISH LH (for Double Cab)

    Click here

  3. INSTALL REAR DOOR SCUFF PLATE LH (for Double Cab)

    Click here

  4. INSTALL FRONT DOOR SCUFF PLATE LH

    for Single Cab:

    Click here

    for Double Cab:

    Click here

    for Smart Cab:

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. CHECK SRS WARNING LIGHT

    Click here