PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A50

DTC Code DTC Name
C1A50 Brake System Malfunction

DESCRIPTION

When the pre-crash safety system is operating, the millimeter wave radar sensor assembly sends brake control signals to the skid control ECU (brake actuator assembly).

When the millimeter wave radar sensor assembly receives a VSC system malfunction signal from the skid control ECU (brake actuator assembly) via CAN communication, DTC C1A50 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A50 Brake System Malfunction While the ignition switch to ON, the millimeter wave radar sensor assembly receives a VSC system malfunction signal from the skid control ECU (brake actuator assembly) for 0.3 seconds or more.

  • Vehicle stability control system

  • Skid control ECU (Brake actuator assembly)

  • Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

Note


  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one.

  • When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

    Click here

  • The pre-crash safety system uses the CAN communication system. First, confirm that there are no malfunction in the CAN communication system. Refer to How to Proceed with Troubleshooting.

    for LHD: Click here

    for RHD: Click here

PROCEDURE


  1. CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)

    Tech Tips

    Pre-crash safety system DTC C1A50 may be stored due to a malfunction in the VSC system. Therefore, it is necessary to check for and troubleshoot VSC system DTCs first.


    1. Check for DTCs.

      Click here


      Chassis > ABS/VSC/TRC > Trouble Codes
      Result
      Result Proceed to
      Vehicle stability control system DTCs are not output A
      Vehicle stability control system DTCs are output B

    B

    GO TO VEHICLE STABILITY CONTROL SYSTEM Click here

    A

  2. CHECK FOR DTCs (PRE-CRASH SAFETY SYSTEM)


    1. Clear the DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Trouble Codes
      Result
      Result Proceed to
      DTC C1A50 is not output A
      DTC C1A50 is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

  3. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. Replace the millimeter wave radar sensor assembly.

      Click here

    2. Adjust the millimeter wave radar sensor assembly.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK FOR DTCs (PRE-CRASH SAFETY SYSTEM)


    1. Clear the DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Trouble Codes
      Result
      Result Proceed to
      DTC C1A50 is not output A
      DTC C1A50 is output B

    A

    END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE)

    B

    REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) Click here