FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat) INSTALLATION

Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.

Tip:

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

Click here

PROCEDURE

Click here
INSTALL FRONT SEAT AIRBAG ASSEMBLY LH
1. Install the front seat airbag assembly LH with 2 new nuts.
  
  5.5 N*m 56 kgf*cm 49 in.*lbf
  Note:
  - The nuts must not be reused.
  - Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
2. Attach the wire harness clamp.
  
  Note:
  Be careful not to damage the airbag wire harness.
Click here
INSTALL SEATBACK COVER WITH PAD

Click here
Click here
INSTALL FRONT SEAT HEADREST SUPPORT

Click here
Click here
INSTALL FRONT NO. 1 SEATBACK HOOK

Click here
Click here
INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY LH

Click here
Click here
INSTALL FRONT SEAT INNER CUSHION SHIELD LH

Click here
Click here
INSTALL FRONT SEAT CUSHION SHIELD LH

Click here
Click here
INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD LH

Click here
Click here
INSTALL FRONT SEAT ASSEMBLY

Click here
Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
Click here
PERFORM DIAGNOSTIC SYSTEM CHECK

Click here
Click here
CHECK SRS WARNING LIGHT

Click here