Click here

FRONT AIRBAG SENSOR REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front airbag sensor removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here
Memorize steering angle neutral point Pre-collision system

Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    CAUTION:
    B0069A2

    Be sure to read Precaution thoroughly before servicing.

    for Type A:

    Click here

    for Type B:

    Click here

    for Type C:

    Click here

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:
    B00693Q

    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. Click here

    REMOVE NO. 1 RADIATOR GRILLE RETAINER (for Steel Type Bumper)

    Click here

  4. Click here

    REMOVE FRONT BUMPER COVER (for Steel Type Bumper)

    Click here

  5. Click here

    REMOVE FRONT BUMPER COVER (for Resin Type Bumper)

    Click here

  6. Click here

    REMOVE FRONT AIRBAG SENSOR LH


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      • B00693Q

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • B0068ME

        If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the front airbag sensor LH. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.

    3. B0069AA

      Remove the nut.

      Note:

      • Loosen the nut while holding the front airbag sensor LH because the front airbag sensor LH guide is easily damaged.

      • If the front airbag sensor LH has been dropped, replace it with a new one.

    4. B0068XM

      Detach the guide and pull out the front airbag sensor LH.

    5. Disconnect the airbag connector.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. B0068XJC03
        *a Housing Lock *b CPA
        *c CPA Upper Part - -

        Push down the housing lock and slide the CPA. (At this time, the connector cannot be disconnected yet.)

      2. Push the housing lock again and disconnect the connector.

        Note:

        Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.