Click here

STEERING PAD INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

Click here

PROCEDURE


  1. Click here

    INSTALL HORN BUTTON ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:
      B00693Q

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

    3. Support the horn button assembly with one hand.

    4. B002642C01
      *a Connector Lock
      B0069FO Push

      Connect the airbag connector and lock the connector lock.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Connect the horn connector.

    6. Set the horn button assembly to the steering wheel assembly.

    7. Check that the airbag wire harness and horn wire harness are not pinched.

    8. B0027YDC01
      *a Upper Pin
      *b Lower Pin

      Press the horn button assembly with both hands to attach the upper pin to the torsion spring.

    9. Press the horn button assembly with both hands to attach the lower pin to the torsion spring.

      Note:

      After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.

  2. Click here

    INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. B0026B5

      Attach the guide and claw to install the lower No. 2 steering wheel cover.

  3. Click here

    INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. B00293O

      Attach the guide and claw to install the lower No. 3 steering wheel cover.

  4. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. Click here

    INSPECT HORN BUTTON ASSEMBLY


    1. With the horn button assembly installed to the vehicle, perform a visual check. If any of the defects mentioned below are found, replace the horn button assembly with a new one:

      Cuts, minute cracks or marked discoloration on the horn button assembly top surface or in the grooved portion.

    2. Make sure that the horn sounds.

      Tip:

      If the horn does not sound, inspect the horn system.

      Click here

  6. Click here

    PERFORM DIAGNOSTIC SYSTEM CHECK

    for Type A:

    Click here

    for Type B:

    Click here

  7. Click here

    CHECK SRS WARNING LIGHT

    for Type A:

    Click here

    for Type B:

    Click here