CLOCK REMOVAL

CAUTION / NOTICE / HINT

w/ Airbag System:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

1. Click here

   PRECAUTION (w/ Airbag System)

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click here

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. Click here

   REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

   Click here

4. Click here

   REMOVE DEFROSTER NOZZLE ASSEMBLY

   Click here

5. Click here

   REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

   Click here

6. Click here

   REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY

   Click here

7. Click here

   REMOVE NO. 2 HEATER TO REGISTER DUCT

   Click here

8. Click here

   REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

9. Click here

   REMOVE CLOCK ASSEMBLY

   
   
   1. 

      *a	Protective Tape

      Remove the screw.

   2. Using a screwdriver, detach the claw and remove the clock assembly.

      Tip:

      Tape the screwdriver tip before use.