ENTRY LOCK AND UNLOCK SWITCH INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

   
   

   1. Apply MP grease to the sliding area of the front door outside handle assembly LH.

   2. 

      Install in this Direction

      Install the front door outside handle assembly LH by moving it in the direction indicated by the arrow shown in the illustration.

   3. 

      Attach the claw of the connector to connect the connector.

   4. 

      Install in this Direction

      Attach the claws of the connector cover to connect the connector cover.

2. Click here

   INSTALL FRONT DOOR OUTSIDE HANDLE COVER

   
   

   1. Apply MP grease to the sliding parts of the lock cylinder.

   2. Install the front door outside handle cover with lock cylinder.

   3. 

      *1	Hole Plug
      	Install in this Direction

      Using a T30 "TORX" socket wrench, tighten the screw.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

   4. Install the hole plug.

3. Click here

   INSTALL FRONT DOOR SERVICE HOLE COVER LH

   Click here

4. Click here

   INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

5. Click here

   INSTALL FRONT ARMREST ASSEMBLY LH

   Click here

6. Click here

   INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

   Click here

7. Click here

   INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

8. Click here

   INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

   Click here