ENTRY LOCK AND UNLOCK SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  4. REMOVE FRONT ARMREST ASSEMBLY LH

    Click here

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  6. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  7. REMOVE FRONT DOOR OUTSIDE HANDLE COVER


    1. B0026BKC01
      *1 Hole Plug
      B0069FO Remove in this Direction

      Remove the hole plug.

    2. Using a T30 "TORX" socket wrench, loosen the screw.

    3. Remove the front door outside handle cover with lock cylinder.

  8. REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. B00287DC01
      *1 Protective Tape
      B0069FO Remove in this Direction

      Using a screwdriver, detach the claws of the connector cover in the direction indicated by the arrow in the illustration and disconnect the connector cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. B0027DYC01
      *1 Protective Tape
      B0069FO Remove in this Direction

      Using a screwdriver, detach the claw of the connector in the direction indicated by the arrow in the illustration and disconnect the connector.

      Tech Tips

      Tape the screwdriver tip before use.

    3. B0024TOC01
      B0069FO Remove in this Direction

      Remove the front door outside handle assembly LH in the direction indicated by the arrow as shown in the illustration.