ENTRY AND START SYSTEM(for Start Function), Diagnostic DTC:B2277

DTC Code DTC Name
B2277 Detecting Vehicle Submersion

DESCRIPTION

This DTC is stored when a malfunction in the water submersion detection circuit in the certification ECU (smart key ECU assembly) is detected.

Tech Tips

When the cable is disconnected and reconnected to the negative (-) battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2277 Detecting Vehicle Submersion The water submersion detection circuit in the certification ECU (smart key ECU assembly) detects water submersion (1-trip detection logic*).

  • Submersion of certification ECU (smart key ECU assembly) in water

  • Certification ECU (smart key ECU assembly)

 Wait 300 seconds after connecting the cable to the negative (-) battery terminal.

Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
The engine switch cannot be turned off and the engine cannot be started. -
Related Data List and Active Test Items
DTC No. Data List Item Active Test Item
B2277 - -

CAUTION / NOTICE / HINT

Note


  • When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • The entry and start system (for Start Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting Click here. Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.

  • Before replacing the certification ECU (smart key ECU assembly), refer to the entry and start system (for Entry Function) precaution.

    Click here

  • After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

Tech Tips

Before proceeding with troubleshooting, check if there are any signs of water damage to the certification ECU (smart key ECU assembly). If there are any signs of water damage, replace the certification ECU (smart key ECU assembly) and take measures against the cause of the water damage.

PROCEDURE


  1. CHECK WATER INTRUSION


    1. Check that the certification ECU (smart key ECU assembly), its surrounding area and harnesses have no signs of water intrusion.

      Result
      Result Proceed to
      No sign of water intrusion found A
      Signs of water intrusion found B

    A

    REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

    B

    TAKE MEASURES FOR WATER INTRUSION AND REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)