DOOR CONTROL RECEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the door control receiver or smart door control receiver assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-collision system

Click here


    w/o Entry and Start System:

  • Door control transmitter assembly

  • Door control receiver

Recognition code registration Engine starting Refer to the Service Bulletin for the registration procedure.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. PRECAUTION (w/ Airbag System)

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    B0069A2

    for Type A:

    Click here

    for Type B:

    Click here

    for Type C:

    Click here

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B00693Q

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE DOOR CONTROL RECEIVER (w/o Entry and Start System)


    1. B0028U3C01
      B0068HS Nut
      B006964 Connector

      Remove the nut.

    2. Detach the guide and remove the door control receiver.

    3. Disconnect the connector.

  5. REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Entry and Start System)


    1. B0028E6C01
      B0068HS Nut
      B006964 Connector

      Remove the nut.

    2. Detach the guide and remove the smart door control receiver assembly.

    3. Disconnect the connector.