UNLOCK WARNING SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LOWER STEERING COLUMN COVER

    Click here

  4. REMOVE UPPER STEERING COLUMN COVER

    Click here

  5. REMOVE TRANSPONDER KEY COIL (w/ Engine Immobiliser System)

    Click here

  6. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY

    Click here

  7. REMOVE UNLOCK WARNING SWITCH ASSEMBLY


    1. B0027A6C01
      *a Center Part
      B0069FO Remove in this Direction

      Detach the connector.

    2. Push up the center part of the unlock warning switch assembly, detach the claw and remove the unlock warning switch assembly.

      Tech Tips

      Slide the unlock warning switch assembly in the direction indicated by the arrow in the illustration to remove it.