REAR DOOR LOCK(for Double Cab) INSPECTION

PROCEDURE


  1. INSPECT REAR DOOR LOCK ASSEMBLY LH


    1. A01SAUZC06
      *a Unlock
      *b Lock
      *c

      Component without harness connected

      (Rear Door Lock Assembly LH)

      Check the door lock motor operation.


      1. Apply battery voltage to the motor connector and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 4 (L)

        Battery negative (-) → Terminal 1 (UL)

        		 Lock

        Battery positive (+) → Terminal 1 (UL)

        Battery negative (-) → Terminal 4 (L)

        		 Unlock

        If the result is not as specified, replace the rear door lock assembly LH.

    2. Check the operation of the door unlock detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        6 (LSSR) - 9 (E) Lock 10 kΩ or higher
        6 (LSSR) - 9 (E) Unlock Below 1 Ω

        If the result is not as specified, replace the rear door lock assembly LH.

  2. INSPECT REAR DOOR LOCK ASSEMBLY RH


    1. A01SDQYC06
      *a Unlock
      *b Lock
      *c

      Component without harness connected

      (Rear Door Lock Assembly RH)

      Check the door lock motor operation.


      1. Apply battery voltage to the motor connector and check the operation of the door lock motor.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 4 (L)

        Battery negative (-) → Terminal 1 (UL)

        		 Lock

        Battery positive (+) → Terminal 1 (UL)

        Battery negative (-) → Terminal 4 (L)

        		 Unlock

        If the result is not as specified, replace the rear door lock assembly RH.

    2. Check the operation of the unlock detection switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        6 (LSSR) - 9 (E) Lock 10 kΩ or higher
        6 (LSSR) - 9 (E) Unlock Below 1 Ω

        If the result is not as specified, replace the rear door lock assembly RH.