BATTERY CURRENT SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the battery current sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative when not Performed Link

    w/ Stop and Start System:

  • Battery terminal is disconnected/reconnected

 Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. REMOVE BATTERY STATE SENSOR ASSEMBLY (BATTERY STATE SENSOR ASSEMBLY WITH NEGATIVE BATTERY TERMINAL)


    1. B00277A

      Remove the nut and detach the clamp from the battery current sensor holder.

    2. Remove the nut and disconnect the No. 3 engine wire from the battery state sensor assembly.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    3. Disconnect the connector from the battery state sensor assembly.

    4. Loosen the nut and disconnect the battery state sensor assembly from the battery.

    5. B00249T

      Detach the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.