CHARGING SYSTEM Charging Failure

PROCEDURE


  1. CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION)


    1. Start the engine and visually check that the generator rotor assembly in the generator assembly is operating.

      OK
      The generator rotor assembly (fan) is operating.
      Result
      Result
      OK
      NG

    NG

    REPLACE GENERATOR PULLEY WITH CLUTCH for 80A Type: Click here for 90A Type: Click here for 100A Type: Click here for 130A Type: Click here

    OK

  2. CHECK GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION)


    1. Remove the generator assembly.


    2. Check the installation condition of the generator pulley cap.

      OK
      The generator pulley cap is not loose or missing.

    3. Check for the formation of particles due to friction (for dry type pulley) or grease leaks (for wet type pulley).

      OK
      There are no grease leaks (for wet type pulley) or a large amount of particles (for dry type pulley).

    4. Check the generator pulley with clutch for misalignment (interference with the generator assembly).

      OK
      The generator pulley with clutch is not misaligned (no interference with the generator assembly).
    5. A01SHL1

      Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise.

      OK
      Noise does not occur when turned in both directions.

    6. Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.

      OK
      The generator pulley with clutch does not have runout.
    7. A01SHDAC04
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, hold the generator rotor assembly in the generator assembly and check that the generator pulley with clutch locks when turned from counterclockwise (free turning direction) to clockwise (locking direction).

      OK
      The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.
      Result
      Result
      OK
      NG

    OK

    REPAIR OR REPLACE GENERATOR ASSEMBLY for 80A Type: Click here for 90A Type: Click here for 100A Type: Click here for 130A Type: Click here

    NG

    REPLACE GENERATOR PULLEY WITH CLUTCH for 80A Type: Click here for 90A Type: Click here for 100A Type: Click here for 130A Type: Click here