GENERATOR(for 90A Type) DISASSEMBLY

Click here Click here

PROCEDURE

1. Click here

   REMOVE GENERATOR PULLEY CAP

   
   
   1. 

      Using a screwdriver, remove the generator pulley cap.

2. Click here

   REMOVE GENERATOR PULLEY WITH CLUTCH

   
   
   1. 

      *a	T50 "TORX" Socket Wrench

      Set SST and a T50 "TORX" socket wrench as shown in the illustration.

      09820-30010

   2. Secure the generator assembly in a vise between aluminum plates.

   3. 

      *a	Hold
      *b	Turn
      *c	T50 "TORX" Socket Wrench

      While holding SST in place, rotate the T50 "TORX" socket wrench clockwise, and remove the generator pulley with clutch.

      Note:

      Check that the generator drive end frame is secured in the vise tightly.