RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK STOP LIGHT CONTROL RELAY (STOP/CDS FAN Relay)


    1. Remove the stop light control relay (STOP/CDS FAN Relay) from the engine room relay block.

    2. A01LDPVN01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 4 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 Below 1 Ω
      Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2 10 kΩ or higher
      3 - 5 Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2 10 kΩ or higher
      Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2 Below 1 Ω

      If the result is not as specified, replace the stop light control relay (STOP/CDS FAN Relay).

    3. Install the stop light control relay (STOP/CDS FAN Relay).