Click here

FRONT SPEED SENSOR(for 2WD) INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL FRONT SPEED SENSOR LH


    1. B0069A0

      Install the harness clamp with the bolt.

      32 N*m 326 kgf*cm 24 ft.*lbf
      Note:

      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    2. Install the front speed sensor LH with the bolt.

      8.5 N*m 87 kgf*cm 75 in.*lbf
      Note:

      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

      • When installing the sensor, do not twist the wire harness.

    3. B0068CM

      Install the harness clamp to the front lower arm bracket with the bolt.

      32 N*m 326 kgf*cm 24 ft.*lbf
      Note:

      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    4. Install the harness clamp to the front absorber bracket with the bolt.

      32 N*m 326 kgf*cm 24 ft.*lbf
      Note:

      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    5. A01LDX8

      Install the harness clamp with the bolt.

      32 N*m 326 kgf*cm 24 ft.*lbf
      Note:

      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    6. Attach the clamp.

    7. A01LFNR

      Attach the 2 clamps and the connector.

      Note:

      When attaching the clamps, do not twist the wire harness.

    8. Connect the connector.

      Note:

      • Do not attach the connector to the radiator fan shroud before connecting the connector.

      • Securely connect the connector.

  2. Click here

    INSTALL FRONT WHEEL

    Click here

  3. Click here

    CHECK ABS SPEED SENSOR SIGNAL


    1. w/ VSC:

      Click here

    2. w/o VSC:

      Click here