STEERING ANGLE SENSOR(w/ VSC) REMOVAL

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

   Click here

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. Click here

   PLACE FRONT WHEELS FACING STRAIGHT AHEAD

4. Click here

   REMOVE STEERING WHEEL ASSEMBLY

   Click here

5. Click here

   REMOVE LOWER STEERING COLUMN COVER

   Click here

6. Click here

   REMOVE UPPER STEERING COLUMN COVER

   Click here

7. Click here

   REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

   Note:
   

   • Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.

   • Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.

   • When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.

   
   
   1. 

      Slide the airbag connector slider as shown in the illustration and disconnect the airbag connector from the spiral with cable sensor sub-assembly.

   2. Disconnect each connector from the spiral with sensor cable sub-assembly.

   3. 

      Detach the 3 claws and remove the spiral with sensor cable sub-assembly.