Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
DATA LIST
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ABS Warning Light | ABS warning light | ON or OFF | OFF: Warning light off ON: Warning light on |
- |
| Brake Warning Light | Brake warning light | ON or OFF | OFF: Warning light off ON: Warning light on |
- |
| Stop Light SW | Stop light switch assembly | ON or OFF | OFF: Brake pedal released ON: Brake pedal depressed |
- |
| Parking Brake SW | Parking brake switch assembly | ON or OFF | OFF: Parking brake released ON: Parking brake applied |
- |
| Inspection Mode | Inspection mode | Other or Inspect | Inspect: Inspection mode Other: Normal mode |
- |
| Deceleration Sensor | Deceleration sensor | Min.: -18.525 m/s2 Max.: 18.387 m/s2 |
- | During deceleration/acceleration: Changes continuously for 2WD other than Pre-Runner: The item is displayed on the GTS but not used. |
| Forward and Rearward G | Forward and backward G | Min.: -25.10 m/s2 Max.: 24.90 m/s2 |
- | During acceleration/deceleration: Changes in proportion with acceleration for 2WD other than Pre-Runner: The item is displayed on the GTS but not used. |
| Rear Diff Lock Switch | Rear differential lock position switch (No. 1 transfer indicator switch) | ON or OFF | OFF: Rear differential lock position switch off ON: Rear differential lock position switch on |
w/ Rear Differential Lock |
| Automatic Disconnect Diff SW |
|
ON or OFF | OFF: 2WD ON: 4WD |
for 4WD |
| L4 Switch | L4 detection switch (transfer shift actuator assembly) | ON or OFF | OFF: except L4 ON: L4 |
for 4WD |
| FR Wheel Speed | Front wheel speed sensor RH reading | Min.: 0 km/h (0 mph) Max.: 326.4 km/h (202 mph) |
Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| FL Wheel Speed | Front wheel speed sensor LH reading | Min.: 0 km/h (0 mph) Max.: 326.4 km/h (202 mph) |
Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| RR Wheel Speed | Rear wheel speed sensor RH reading | Min.: 0 km/h (0 mph) Max.: 326.4 km/h (202 mph) |
Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| RL Wheel Speed | Rear wheel speed sensor LH reading | Min.: 0 km/h (0 mph) Max.: 326.4 km/h (202 mph) |
Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph) Max.: 326.4 km/h (202 mph) |
Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| FR Wheel Acceleration | Front wheel RH acceleration | Min.: -200.84 m/s2 Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| FL Wheel Acceleration | Front wheel LH acceleration | Min.: -200.84 m/s2 Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| RR Wheel Acceleration | Rear wheel RH acceleration | Min.: -200.84 m/s2 Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| RL Wheel Acceleration | Rear wheel LH acceleration | Min.: -200.84 m/s2 Max.: 199.27 m/s2 |
- | During deceleration/acceleration: Changes continuously |
| FR Wheel ABS Ctrl Status | Front wheel RH ABS control status | ON or OFF | OFF: Not during control ON: During control |
- |
| FL Wheel ABS Ctrl Status | Front wheel LH ABS control status | ON or OFF | OFF: Not during control ON: During control |
- |
| RR Wheel ABS Ctrl Status | Rear wheel RH ABS control status | ON or OFF | OFF: Not during control ON: During control |
- |
| RL Wheel ABS Ctrl Status | Rear wheel LH ABS control status | ON or OFF | OFF: Not during control ON: During control |
- |
| RR Wheel EBD Ctrl Status | Rear wheel RH EBD control status | ON or OFF | OFF: Not during control ON: During control |
- |
| RL Wheel EBD Ctrl Status | Rear wheel LH EBD control status | ON or OFF | OFF: Not during control ON: During control |
- |
| Solenoid Relay | Solenoid relay | ON or OFF | OFF: Solenoid relay off ON: Solenoid relay on |
- |
| ECB Motor Relay | Motor relay | ON or OFF | OFF: Motor relay off ON: Motor relay on |
Tech Tips ECB: Electronically Controlled Brake System |
| ABS Solenoid (SFRH) | ABS solenoid (SFRH) | ON or OFF | OFF: Not operating ON: Operating |
- |
| ABS Solenoid (SFRR) | ABS solenoid (SFRR) | ON or OFF | OFF: Not operating ON: Operating |
- |
| ABS Solenoid (SFLH) | ABS solenoid (SFLH) | ON or OFF | OFF: Not operating ON: Operating |
- |
| ABS Solenoid (SFLR) | ABS solenoid (SFLR) | ON or OFF | OFF: Not operating ON: Operating |
- |
| ABS Solenoid (SRRH) | ABS solenoid (SRRH) | ON or OFF | OFF: Not operating ON: Operating |
- |
| ABS Solenoid (SRRR) | ABS solenoid (SRRR) | ON or OFF | OFF: Not operating ON: Operating |
- |
| ABS Solenoid (SRLH) | ABS solenoid (SRLH) | ON or OFF | OFF: Not operating ON: Operating |
- |
| ABS Solenoid (SRLR) | ABS solenoid (SRLR) | ON or OFF | OFF: Not operating ON: Operating |
- |
| FR Speed Open | Front speed sensor RH open detection | Error or Normal | Normal | Error: Momentary interruption |
| FL Speed Open | Front speed sensor LH open detection | Error or Normal | Normal | Error: Momentary interruption |
| RR Speed Open | Rear speed sensor RH open detection | Error or Normal | Normal | Error: Momentary interruption |
| RL Speed Open | Rear speed sensor LH open detection | Error or Normal | Normal | Error: Momentary interruption |
| EFI Communication Open | ECM communication open detection | Error or Normal | Normal | Error: Momentary interruption |
| Deceleration Open | Deceleration sensor open detection | Error or Normal | Normal | Error: Momentary interruption for 4WD and Pre-Runner |
| IG1 Voltage Value | IG1 voltage value | Min.: 0 V Max.: 20 V |
Ignition switch ON: 11 to 14 V | Changes in proportion to battery voltage |
| MT Voltage Value | Motor voltage value | Min.: 0 V Max.: 20 V |
- | Changes in proportion to battery voltage |
| Number of DTC | Number of DTCs recorded | Min.: 0 Max.: 255 |
- | - |
| IG Voltage Value Decreased | IG voltage value decrease detection | Error or Normal | Normal | Error: Voltage low |
| IG Voltage Value Increased | IG voltage value increase detection | Error or Normal | Normal | Error: Voltage high |
| FR Speed Sensor Voltage Open | Front speed sensor RH voltage open detection | Error or Normal | Normal | Error: Momentary interruption |
| FL Speed Sensor Voltage Open | Front speed sensor LH voltage open detection | Error or Normal | Normal | Error: Momentary interruption |
| RR Speed Sensor Voltage Open | Rear speed sensor RH voltage open detection | Error or Normal | Normal | Error: Momentary interruption |
| RL Speed Sensor Voltage Open | Rear speed sensor LH voltage open detection | Error or Normal | Normal | Error: Momentary interruption |
| EFI Communication Invalid | ECM communication invalid detection | Error or Normal | Normal | Error: Invalid |
| 4WD LOCK Switch | 4WD position switch signal | ON or OFF | OFF: 2WD ON: 4WD |
for 4WD |
*1: w/ A.D.D. Actuator
*2: w/o A.D.D. Actuator
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSV, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| ABS Warning Light | ABS warning light | Warning light ON/OFF | Observe combination meter assembly Vehicle condition: Vehicle stopped |
| Brake Warning Light | Brake warning light | Warning light ON/OFF | Observe combination meter assembly Vehicle condition: Vehicle stopped |
| Solenoid Relay | Solenoid relay | Relay ON/OFF | Vehicle condition: Vehicle stopped |
| Motor Relay | Motor relay | Relay ON/OFF | Operating sound of motor can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRLR) | ABS solenoid (SRLR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRLH) | ABS solenoid (SRLH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRRR) | ABS solenoid (SRRR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRRH) | ABS solenoid (SRRH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFLR) | ABS solenoid (SFLR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFLH) | ABS solenoid (SFLH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFRR) | ABS solenoid (SFRR) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFRH) | ABS solenoid (SFRH) | Solenoid ON/OFF | Operating sound of solenoid (clicking sound) can be heard. Vehicle condition: Vehicle stopped |
| ABS Solenoid | Selection of multiple holding solenoids (SFRH, SFLH, SRRH and SRLH) and pressure reduction solenoids (SFRR, SFLR, SRRR and SRLR) possible | Start/Stop | Vehicle condition: Vehicle stopped |