REAR SHOCK ABSORBER(for 2WD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The RH side rear shock absorber assembly RH lower protector should face to the front side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

    A01LB5C

    1. Install the 2 No. 1 rear shock absorber cushion washers to the axle housing.

    2. Install 4 new rear shock absorber bushes to the rear shock absorber assembly LH.

    3. Install the rear shock absorber assembly LH and 4 rear shock absorber bushes to the U bolt seat and frame.

    4. Install the 2 rear No. 2 shock absorber cushion washers.

    5. Temporarily install the 2 bolts.

  2. INSTALL REAR WHEEL

    Click here

  3. STABILIZE SUSPENSION


    1. Lower the vehicle.

    2. Bounce the vehicle up and down several times to stabilize the suspension.

  4. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH


    1. Tighten the 2 bolts.

      Torque:
      105 N*m  { 1071 kgf*cm, 77 ft.*lbf }