FRONT LOWER SUSPENSION ARM(for 2WD) INSPECTION

Click here Click here

PROCEDURE

1. Click here

   INSPECT FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH

   
   

   1. As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.

   2. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

      Turning torque
      0.29 to 4.5 N*m (3 to 45 kgf*cm, 3 to 39 in.*lbf)

   3. Check for any cracks and grease leaks on the ball joint dust cover.