REAR DIFFERENTIAL CARRIER ASSEMBLY(for DANA Made w/ Differential Lock) COMPONENTS
ILLUSTRATION
| *A | for 1GD-FTV (RC61), 2GD-FTV (RC60) | - | - |
| *1 | REAR DIFFERENTIAL CARRIER ASSEMBLY | *2 | REAR DIFFERENTIAL CARRIER GASKET |
| *3 | REAR DIFFERENTIAL PROTECTOR | *4 | REAR PROPELLER SHAFT ASSEMBLY |
| *5 | GASKET | *6 | REAR AXLE HOUSING FILLER PLUG |
| *7 | REAR AXLE HOUSING DRAIN PLUG | *8 | DIFFERENTIAL TORSIONAL DAMPER |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part |  |
Do not apply lubricants |
ILLUSTRATION
| *1 | DIFFERENTIAL BEARING CAP | *2 | DIFFERENTIAL DRIVE PINION |
| *3 | DIFFERENTIAL OIL STORAGE RING | *4 | ELECTRONIC DIFFERENTIAL LOCK CASE SUB-ASSEMBLY |
| *5 | NO. 1 TRANSFER INDICATOR SWITCH (REAR DIFFERENTIAL LOCK POSITION SWITCH) | *6 | REAR DIFFERENTIAL CARRIER ASSEMBLY |
| *7 | REAR DIFFERENTIAL CARRIER OIL SEAL | *8 | REAR DIFFERENTIAL DRIVE PINION BEARING SPACER |
| *9 | REAR DIFFERENTIAL DRIVE PINION OIL SLINGER | *10 | REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY WITH DUST DEFLECTOR |
| *11 | REAR DRIVE PINION FRONT TAPERED ROLLER BEARING | *12 | REAR DRIVE PINION NUT |
| *13 | REAR DRIVE PINION REAR TAPERED ROLLER BEARING | *14 | WIRING HARNESS CONNECTOR |
| *15 | ADJUST SHIM | *16 | PLATE WASHER |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
MP grease |  |
Hypoid gear oil LSD |
ILLUSTRATION
| *1 | DIFFERENTIAL LOCK CAM RING | *2 | DIFFERENTIAL LOCK COIL |
| *3 | DIFFERENTIAL LOCK PLUNGER | *4 | DIFFERENTIAL LOCK POSITION PLATE |
| *5 | DIFFERENTIAL RING GEAR | *6 | DIFFERENTIAL SOLENOID WASHER |
| *7 | REAR DIFFERENTIAL CASE BEARING | *8 | DIFFERENTIAL CASE LH |
| *9 | DIFFERENTIAL CASE RH | *10 | DIFFERENTIAL PINION |
| *11 | DIFFERENTIAL SIDE GEAR (DOG CLUTCH) | *12 | DIFFERENTIAL SIDE GEAR |
| *13 | REAR DIFFERENTIAL PINION THRUST WASHER | *14 | REAR NO. 1 DIFFERENTIAL SIDE GEAR THRUST WASHER |
| *15 | REAR NO. 2 DIFFERENTIAL SIDE GEAR THRUST WASHER | *16 | REAR NO. 3 DIFFERENTIAL SIDE GEAR THRUST WASHER |
| *17 | DIFFERENTIAL LOCK SPRING | *18 | REAR DIFFERENTIAL PINION SHAFT |
| *19 | REAR NO. 2 DIFFERENTIAL PINION SHAFT | *20 | REAR DIFFERENTIAL PINION SHAFT PIN |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Hypoid gear oil | ★ | Precoated part |