Click here

REAR DIFFERENTIAL CARRIER ASSEMBLY(for DANA Made w/o Differential Lock) REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

  • B00281GC03
    *a Object Exceeding Weight Limit of Transmission Jack

    Be sure to perform this procedure with several people as the rear differential carrier assembly is very heavy.

  • Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.

Tip:

The following procedures are for BD22 (w/o Differential Lock).

Click here

PROCEDURE


  1. Click here

    REMOVE REAR WHEEL

    Click here

  2. Click here

    REMOVE REAR PROPELLER SHAFT ASSEMBLY

    Click here

  3. Click here

    DRAIN DIFFERENTIAL OIL

    Click here

  4. Click here

    REMOVE REAR AXLE SHAFT WITH BACKING PLATE LH

    Click here

  5. Click here

    REMOVE REAR AXLE SHAFT WITH BACKING PLATE RH

    Tip:

    Use the same procedure described for the LH side.

  6. Click here

    REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY


    1. A01W8A7

      Remove the 10 nuts, 10 washers and rear differential carrier assembly.

      CAUTION:

      The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

      Note:

      • Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

      • The remaining oil may leak out when removing the rear differential carrier assembly.

      • Do not damage the installation surface when removing the rear differential carrier assembly.

      • Remove the bolts with the rear differential carrier assembly secured.

  7. Click here

    REMOVE REAR DIFFERENTIAL CARRIER GASKET