NAVIGATION ANTENNA INSPECTION

PROCEDURE


  1. INSPECT NAVIGATION ANTENNA ASSEMBLY


    1. A01LEUUC01
      *a

      Component without harness connected

      (Navigation Antenna Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Always 50 to 500 Ω

      If the result is not as specified, replace the navigation antenna assembly.

  2. INSPECT NO. 2 NAVIGATION ANTENNA CORD SUB-ASSEMBLY


    1. Measure the resistance according to the value(s) in the table below.

      A01L9UJC01
      *a

      Component without harness connected

      (No. 2 Navigation Antenna Cord Sub-assembly)

      		 - -
      Standard Resistance
      Tester Connection Condition Specified Condition
      A-1 - B-1 Always Below 1 Ω
      A-2 - B-2 Always Below 1 Ω

      If the result is not as specified, replace the No. 2 navigation antenna cord sub-assembly.