FRONT AXLE HUB(for 2WD) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

    Click here

  2. DISCONNECT FRONT FLEXIBLE HOSE

    Click here

  3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  4. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH

    Click here

  5. REMOVE FRONT DISC

    Click here

  6. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A01LENV

      Using a dial indicator, check for looseness near the center of the front axle hub.

      Maximum
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the front axle hub sub-assembly.

  7. INSPECT FRONT AXLE HUB RUNOUT


    1. A01L99J

      Using a dial indicator, check for runout on the surface of the front axle hub inside the front axle hub bolt.

      Maximum
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the runout is more than the maximum, replace the front axle hub sub-assembly.

  8. INSTALL FRONT DISC

    Click here

  9. INSTALL FRONT DISC BRAKE CYLINDER MOUNTING LH

    Click here

  10. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH

    Click here

  11. CONNECT FRONT FLEXIBLE HOSE

    Click here

  12. INSTALL FRONT WHEEL

    Click here