FRONT DRIVE SHAFT ASSEMBLY INSPECTION

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    1. A01SB2A

      Check that there is no excessive play in the radial direction of the inboard joint and outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no excessive play in the radial direction of the inboard joint.

    4. Check that the inboard joint boot and outboard joint boot are not cracked or damaged, and no grease is leaking out.

    5. A01SB8QN06

      Check that the inboard joint boot and outboard joint boot are not stretched or contracted when the front drive shaft assembly is at the standard length.

      Length (A)
      Item Length
      for LH Side 555.9 mm (1.82 ft.)
      for RH Side

      Note

      Keep the front drive shaft assembly level during inspection.

      If the inboard joint boot and outboard joint boot are stretched or contracted, correct them.